The following problems occur in the BQ34Z100 demo test. 1. During the discharge process at 0℃ 1C, the SoC jumps directly from 100% to 0%, and the capacity almost becomes 0. The parameters are as ...

I've successfully configured the BQ76942 in my system and everything seems to be working fine. I've done this development using the EV2400. I would now like to OTP the part using the EV2400. I've ...

We have question from our customer regards to bq25629 application. Hope you can help, thanks in advance. Our customer is looking at using bq25629 as battery charging for pointing device (Mouse) design ...

I am using PIC32MZ2064DAS169i micro controller with DP83848 PHY. I have interfaced the DP83848 PHY driver library in MPLAB version 6.20 harmony library. When i am ...

I need to operate a 4x4 matrix to find its inverse in my firmware. I was trying to see if there was a function from any TI library can be used for that. So far, I haven't found any. 1. Please confirm ...

Order of millivolts output swing to be fed into an ADC I'm using currently using TINA-TI to simulate the TIA, with the ultimate goal of producing a tangible physical version of the circuit in the ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

I am looking for software help on a CAN interface that is on the TI CP3UB26 microcontroller as well as on the NatSemi/TI CR16 family. Does TI have any software drivers for this CAN peripheral? Thank ...

When the Init bit (CCCR.INIT) is cleared by your code, the MCAN module will then wait for 129 occurrences of Bus Idle (129 × 11 consecutive recessive bits) before resuming normal operation. After the ...

I have received a .DAT file from the mmWave Visualizer. How can I open/analyze this file using Matlab? I am trying to get the points information, is there has matlab or python code?

Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...

Reg63 ”DAC Channel Volume Control's Soft-Step control”...Soft-Stepping is 1 step per 1 or 2 DAC Word Clock I would like to check whether there is any pop noise when switching from maximum volume to ...